HP NC310F PCI-X Gigabit Server Adapter - Manual (Page 10)

Installing the Adapter
2-2 HP NC310F PCI-X Gigabit Server Adapter User Guide
Installing the Adapter in a Server
Refer to the HP ProLiant server documentation for additional information on how to safely
install a PCI card in the server.
Figure 2-1: Installing the adapter in a server
WARNING: If the server is not PCI Hot Plug compliant, power it down and unplug the
power cord from the power outlet before removing the server cover. Failure to do so
may damage the adapter or server.
1. Remove the power cord and server cover. Then remove the cover bracket from a
PCI/PCI-X slot.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching them.
2. Firmly seat the adapter in the PCI/PCI-X slot and secure the adapter bracket.
3. Replace the server cover and plug in the power cord.
Connecting the Network Cable
The HP NC310F PCI-X Gigabit Server Adapter uses an LC fiber port. This port supports
multimode fiber with a maximum cable length dependent on the fiber type, mode, and cable
size. Refer to Appendix C for maximum the cable length.
To insert the LC connector into the adapter port, line up the slot on the fiber connector with
the adapter and gently push until the retainers click into place.