Wizards, Create iscsi target wizard – HP ProLiant DL160 G5 Storage-Server User Manual
Page 123
Wizards
To support creation and management of iSCSI targets, virtual disks, and snapshots, the iSCSI Software
Target snap-in provides several wizards.
Create iSCSI Target Wizard
This section describes how to create an iSCSI Target using the Create iSCSI Target Wizard.
1.
Log on to the storage server using an account with administrative privileges.
2.
Open the Microsoft iSCSI Software Target MMC snap-in by clicking Start > Programs >
Administrative Tools > Microsoft iSCSI Software Target.
3.
Click the iSCSI Targets node. On the details view (right pane), right-click and select Create iSCSI
Target.
4.
Click Next on the Welcome page of the wizard.
5.
On the iSCSI Target Identification page, type a name and description for the iSCSI Target and
then click Next.
6.
On the iSCSI Initiators Identifiers page, type the iSCSI Qualified Name (IQN) of the iSCSI initiator
requesting access to the iSCSI Target in the IQN identifier field. The IQN is found on the General
tab of the Microsoft iSCSI Initiator interface.
Figure 36 iSCSI Initiators Identifiers page
7.
To enter additional identifiers, or if you are using an identifier other than an IQN (DNS domain
name, IP address, or MAC address):
a.
Click Advanced.
b.
On the Advanced Identifiers page, click Add.
c.
Select the identifier type from the Identifier Type list and type the identifier in the Value field.
d.
Repeat steps b and c for each identifier you want to add.
e.
Click OK.
f.
Click OK again to close the Advanced Identifiers page.
HP ProLiant Storage Server
123