HP XP P9000 for Compatible PAV Software Licenses - Manual (Page 20)

DEVSERV QPAV commands
The MVS DEVSERV QPAV commands can be used for the following functions.
•
Display the status of Parallel Access Volumes base devices. Use the following syntax for this
command.
DS QP,device_unit_ID,4
The following figure shows a sample output of this command.
•
Display the status of a Hyper Parallel Access Volumes base device and its alias devices. Use
the following syntax for this command.
DS QP,device_unit_ID,HPAV
The following figure shows a sample output of this command.
•
Display the status of an entire SSID. Use the following syntax for this command.
DS QP,SSID=device_unit_ID
The following figure shows a sample output of this command.
20 Verifying and monitoring devices