HP Photosmart 422 Portable Photo Studio User Manual
Page 27
Dock the camera on the printer:
1.
Open the camera dock cover, if necessary.
2.
Hold the camera so the camera Image Display faces you and the bottom of the
camera is down.
3.
Make sure the camera is turned off.
4.
Press the camera into the dock so that the connector tab in the camera dock
plugs into the connector slot on the bottom of the camera.
5.
In most cases, docking the camera turns on both the printer and the camera. If it
does not, press the On button on the printer control panel.
Note
While the camera is docked, the camera Image Display dims after eight
minutes of inactivity. The camera Image Display turns back on if a print job is
sent from a connected computer or device with Bluetooth wireless technology,
or if you press any button on the HP PhotosmartGoGo Photo Studio. After ten
idle minutes, the camera Image Display turns off completely. Press the On
button on the printer control panel to wake the display.
Chapter 2
22
HP Photosmart 420 series GoGo Photo Studio