HP ProLiant ML110 G4 Server - Manual (Page 12)

Using the Command Line Utility 12
hrconf rescan
This command enables the controller to detect the removal of any disk drives in the ready state and to detect the
connection of any new disk drives to the controller. The command returns when the rescan is complete.
Syntax
hrconf rescan <Controller#>
Parameters
Controller# is the controller number.
Example
hrconf rescan 1
Return values
SUCCESS: 0x00 indicates the command completed successfully.
FAILURE: 0x01 indicates the command failed.
hrconf restore
This command restores the controller configuration by importing its configuration settings from a specified file and
deletes the current configuration. The file must have been saved through the
BACKUP command from a controller
of the same type with the same number and type of physical drives and having the same channels and device
IDs. A reboot is required for the configuration change to take effect.
Syntax
hrconf restore <Controller#> <Filename> [noprompt]
Parameters
Controller# is the controller number.
Filename is the name of the file from which to read the configuration.
noprompt : No prompt for confirmation.
Example
hrconf restore 1 c:\windows\hr2200 noprompt
Return values
SUCCESS: 0x00 indicates the command completed successfully.
FAILURE: 0x01 indicates the command failed.
BAD_PATH: 0xFF indicates that the path provided is incorrect.
FAILURE: 0xFE indicates an error occurred writing the configuration file.
hrconf setconfig
This command resets the configuration of the controller.
Syntax
hrconf setconfig <Controller#> DEFAULT [noprompt]
Parameters
Controller# is the controller number.
Default : Logical drives are deleted, disk drives are reset to the ready state, and any controller settings are reset
to default values.
noprompt : No prompt for confirmation.
Example
hrconf setconfig 1 default noprompt