Secure the rdx removable disk backup system, Mounting hardware used (hp proliant), Secure the rdx removable disk – HP RDX Removable Disk Backup System User Manual
Page 12: Secure the rdx
2.
Attach a spare power cable from the server or workstation's internal power supply to the
power connector.
Figure 7 Attaching USB and power cable
USB cable
2 and 5
Power cable
1 and 4
server or workstation's power supply
6
RDX Removable Disk Backup System
3
Secure the RDX Removable Disk Backup System
NOTE:
The latches and side views of your server or workstation model may not be exactly the
same as shown in the illustrations. Please refer also to you system's documentation.
Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in
. The server also incorporates a locking mechanism to hold the RDX Removable
Disk Backup System in place.
1.
Push the server latch down to lock the drive into position.
2.
Ensure blanking plates are in place over empty bays and replace the cover on the server.
12
Installing an HP RDX USB 3.0 Internal Removable Disk Backup System