HP RP7 Retail System Model 7800 - Manual (Page 25)

LED and Beeper Indications
The scanner’s beeper sounds and its LED illuminates to indicate various functions or errors on the
scanner. An optional “Green Spot” also performs useful functions. The following tables list these
indications. One exception to the behaviors listed in the tables is that the scanner’s functions are
programmable, and so may or may not be turned on. For example, certain indications such as the
power-up beep can be disabled using programming bar code labels.
Indicator Description LED Beeper
Power-up Beep The scanner is in the
process of powering-up. N/A Scanner beeps four times at
highest frequency and
volume upon power-up.
Good Read Beep A label has been
successfully scanned by the
scanner. LED behavior for this
indication is configurable via
the feature “Good Read:
When to Indicate” (see the
PRG for information). The scanner will beep once
at current frequency, volume,
mono/bitonal setting and
duration upon a successful
label scan.
ROM Failure There is an error in the
scanner's software/
programming. Flashes Scanner sounds one error
beep at highest volume.
Limited Scanning Label
Read Indicates that a host
connection is not
established. N/A Scanner 'chirps' six times at
the highest frequency and
current volume.
Scanner Active Mode The scanner is active and
ready to scan. The Illumination LED is lit
steadily
1
N/A
Scanner Disabled The scanner has been
disabled by the host. The LED blinks continuously N/A
Green Spot 1 flashes
momentarily
Upon successful read of a
label, the software shall turn
the green spot on for the
time specified by the
configured value. N/A N/A
Image Capture Capturing an Image Upon image capture light
blinks once and will blink
multiple during larger image
transfers N/A
1 Except when in sleep mode or when a Good Read LED Duration other than 00 is selected
Programming Mode - The following indications ONLY occur when the scanner is in Programming
Mode.
INDICATION DESCRIPTION LED BEEPER
Label Programming Mode
Entry A valid programming label
has been scanned. LED blinks continuously Scanner sounds four low
frequency beeps.
Label Programming Mode
Rejection of Label A label has been rejected. N/A Scanner sounds three times
at lowest frequency and
current volume.
Scanner Configurator Mode Scanner is in support mode
ready for configuration
change. The Indicator LED is lit
steady N/A
LED and Beeper Indications 19