HP Lights-Out 100 Remote Management - Manual (Page 20)

Using Integrated Lights-Out 100 20
6. Press the down arrow (↓) key to scroll down to BIOS Serial Console Redirection, and press the
Enter key to enter the submenu.
7. Enable the BIOS Serial Console option.
8. Press the down arrow (↓) key to scroll down to Serial Over LAN (SOL), and press the Enter key
to enter the submenu.
9. Enable the Serial Over LAN option.
10. Press the Esc key to return to the previous screen, or press the F10 key to save the changes and exit
Setup.
11. Follow the instructions in the "Additional network settings (on page 27 )" section to set or obtain a
valid IP address.
12. Press the F10 key to save the changes and exit Setup.
13. Now that console redirection has been configured, you can view the boot process remotely by
establishing a telnet session to the IP address of the remote management processor from a client PC.
Consult your operating system documentation for further details on establishing telnet sessions.
NOTE: If you encounter problems logging in to the remote console, be aware that some telnet programs
might require you to enable their send line feed at end of line option. If the remote console does
not respond to the Enter key, try setting this option in your telnet program.
NOTE: You must follow the instructions in the "Additional network settings (on page 27 )" section to
configure the network access properly.
Microsoft Windows EMS management
Microsoft® Windows® Server 2003 provides text-based console access. You can connect a laptop to the
remote management processor to perform basic management tasks on the ProLiant ML110 G3 target
system. The Windows® EMS Console, if enabled, displays the processes that are running and enables
administrators to halt processes. This capability is important in cases in which video, device drivers, or
other operating system features have prevented normal operation and normal corrective actions.
To enable Windows® EMS management on the target ProLiant ML110 G3 server:
1. Press the F10 key during POST to enter the BIOS Setup Utility.
2. Press the right arrow (→) key to navigate to the Advanced menu.
3. Press the down arrow (↓) key to scroll down to the ACPI Configuration option, and press the Enter
key to enter the submenu.
4. Set EMS support (SPCR) to Enabled.
5. Press the Esc key to return to the previous screen, or press the F10 key to save the changes and exit
Setup.
You can now view the Windows® EMS management console remotely by establishing a telnet session to
the IP address of the target server from a client PC. Consult your operating system documentation for
further details on establishing telnet sessions.
NOTE: If you encounter problems logging in to the remote console, be aware that some telnet programs
might require you to enable their send line feed at end of line option. If the remote console does
not respond to the Enter key, try setting this option in your telnet program.
NOTE: You must follow the instructions in the "Additional network settings (on page 27 )" section to
configure the network access properly.