HP ProDisplay P201 20-inch LED Backlit Monitor - Manual (Page 15)

The monitor automatically scans the signal inputs for an active input and uses that input for the display.
If two or more inputs are active, the monitor will display the default input source. If the default source is
not one of the active inputs, then the monitor will display the highest ranking priority input in the
following order: DVI then VGA. You can change the default source in the OSD by pressing the front
panel Menu button and selecting Source Control > Default Source.
Removing the Monitor Stand
You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are both disconnected.
1. Disconnect and remove the signal and power cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Remove the four screws (1) attaching the stand to the monitor and lift the stand (2) off the monitor.
Figure 2-8 Removing the Screws Attaching the Stand to the Monitor
Mounting the Monitor
The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
Removing the Monitor Stand 9