Line interface on the backup host – HP 3PAR Application Software Suite for Oracle User Manual
Page 93
4.43
Recovery Manager Configuration Files
Recovery Manager 3.0.3/3.0.4 for Oracle User’s Guide
4.9.2 Creating a Recovery Manager Configuration File Using Remote Copy
Before creating the configuration files for Recovery Manager to use, you must do the
following:
■
Set up physical links between the local and remote InServ systems. Refer to the 3PAR
Remote Copy User’s Guide for instructions on setting up links.
■
Set up Remote Copy targets for the local and remote InServ systems.
■
Create one Remote Copy groups, assign all virtual volumes used by datafiles and archive log
destinations to the group.
■
Start Remote Copy and verify its setup.
4.9.2.1 Creating Configuration Files using the Menu Driven Application or
Command Line Interface on the Backup Host
To create the Recovery Manager configuration files:
1
From the backup host, start Recovery Manager.
2
If you are using the CLI, from the backup host, issue
/opt/3par/vcdbaora/bin/
vcdba_config
, and then skip to
.
3
If you are using the menu-driven application, from the backup host:
a
Select option 1, Configuration Administration.
b
Select option 1, Create A Backup Configuration.
4
When prompted, press
ENTER
.
5
When prompted, answer the following questions:
CAUTION: If Veritas Volume Manager is being used when assigning 3PAR virtual
volumes to Remote Copy groups, all volumes in the same Veritas disk group
should be assigned to one Remote Copy group, whether they are actually being
used by the Oracle database or not. Otherwise, you might not be able to import
and mount file systems on the remote backup host. Therefore, it is strongly
suggested that Veritas disk groups only contain files used by one Oracle database.
<backup_host># /opt/3par/vcdbaora/bin/vcdba_main