HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 9)

Commands 9
• Health: OK, Degraded, Failed, other
• IP Address
• Connectivity Test
• For VC-Enet Modules:
o VCM Mode: Primary, Backup, Subordinate, Unintegrated
o Module Configuration: In Sync, Not In Sync, Invalid
o Domain Configuration (for primary or backup VC-Enet modules): In Sync, Not In Sync
The primary Virtual Connect manager saves the domain configuration data to the backup module in a VC
domain at a regular interval. The 'Domain configuration' state indicates whether or not this data is in sync
between the two modules.
The 'Module configuration' state indicates whether all the modules in an enclosure are in sync with the
primary module regarding the Virtual Connect configuration information.
If a module is being reconfigured by Virtual Connect, or is rebooting, a 'Not In Sync' or 'Invalid'
configuration status might appear. Wait up to 2 minutes, and then execute the healthcheck command
again.
Item Description
Syntax vcutil -a healthcheck -i <IP> -u <USER> -p <PWD>
Parameters:
IP IP address of the active OA in the enclosure*
USER Name of the OA user with privileges to access all enclosure interconnect bays
PWD Password of the OA user
*In a multi-enclosure environment, this must be the IP address of the active OA in the primary enclosure.
Example
List the state of modules in an enclosure:
vcutil -a healthcheck -i 192.168.0.100 -u Administrator -p password
packageinfo
Extract the package information from the supplied package path and display the following information:
• Digital Signature Validation (for Virtual Connect firmware version 2.30 and higher)
• Package Version
• Ethernet Firmware Version Timestamp
• Ethernet Firmware Supported Hardware
• FC Firmware Version
• FC Firmware Supported Hardware
• Release Notes (extract, not display)
Item Description
Syntax vcutil -a packageinfo -l <FILE>
Parameter: