HP StorageWorks Scalable File Share User Manual
Hp scalable file share user guide, G3.2-0
Advertising
Table of contents
Document Outline
- HP Scalable File Share User Guide
- Table of Contents
- About This Document
- 1 What's In This Version
- 2 Installing and Configuring MSA Arrays
- 3 Installing and Configuring HP SFS Software on Server Nodes
- 3.1 Supported Firmware
- 3.2 Installation Requirements
- 3.3 Installation Phase 1
- 3.4 Installation Phase 2
- 3.5 Configuration Instructions
- 3.6 Upgrade Installation
- 4 Installing and Configuring HP SFS Software on Client Nodes
- 5 Using HP SFS Software
- 5.1 Creating a Lustre File System
- 5.2 Configuring Heartbeat
- 5.3 Starting the File System
- 5.4 Stopping the File System
- 5.5 Monitoring Failover Pairs
- 5.6 Moving and Starting Lustre Servers Using Heartbeat
- 5.7 Testing Your Configuration
- 5.8 Lustre Performance Monitoring
- 6 Licensing
- 7 Known Issues and Workarounds
- 7.1 Server Reboot
- 7.2 Errors from install2
- 7.3 Application File Locking
- 7.4 MDS Is Unresponsive
- 7.5 Changing group_upcall Value to Disable Group Validation
- 7.6 Configuring the mlocate Package on Client Nodes
- 7.7 System Behavior After LBUG
- 7.8 SELinux Support
- 7.9 Misconfigured Lustre target config logs due to incorrect CSV file used during lustre_config
- 7.10 MSA2000fc G1 incorrect MSA cabling between MSA2212fc controllers and SAN switches with zoned SAN switch.
- 7.11 Standby server does not take over neighboring resources
- A HP SFS G3 Performance
- Index