HP XP P9000 Auto LUN Software User Manual
Page 48
Table 25 RAID Manager errors related to manual migration plans (continued)
Required Action
Message
Error Code
(SSB2)
Set an LU path to the volume and then migrate the
volume.
The volume specified as a migration target volume
has no LU path.
20BB
The volume cannot be migrated. Check the
configuration definition file.
The emulation type of the migration source volume
is 3390-V.
20c0
The volume cannot be migrated. Check the
configuration definition file.
The emulation type of the migration target volume
is 3390-V.
20c1
The volume cannot be migrated. Check the
configuration definition file.
The emulation type of the migration source volume
is 6588-A.
20c6
The volume cannot be migrated. Check the
configuration definition file.
The emulation type of the migration target volume
is 6588-A.
20c7
If Mainframe Fibre CHAs are not installed, install
them.
The emulation type of the migration source volume
is 3390-A, and one of the following applies:
20cc
If all Mainframe Fibre CHAs are being blocked,
restore them.
•
Mainframe Fibre CHAs are not installed.
•
All Mainframe Fibre CHAs are being blocked.
If Mainframe Fibre CHAs are not installed, install
them.
The emulation type of the migration target volume
is 3390-A, and one of the following applies:
20cd
If all Mainframe Fibre CHAs are being blocked,
restore them.
•
Mainframe Fibre CHAs are not installed.
•
All Mainframe Fibre CHAs are being blocked.
Perform the operation again after the initialization
of the THP pool has finished.
The migration source volume is a Thin Provisioning
or Smart Tiers virtual volume whose THP pool is
being initialized.
20d3
Perform the operation again after the initialization
of the THP pool has finished.
The migration target volume is a Thin Provisioning
or Smart Tiers virtual volume whose THP pool is
being initialized.
20d4
The volume cannot be migrated. Check the
configuration definition file.
The migration source volume is a TSE-VOL.
20d9
The volume cannot be migrated. Check the
configuration definition file.
The migration target volume is a TSE-VOL.
20da
Perform the operation again after checking the
configuration definition file.
The settings for online data migration of the source
volume is incorrect.
20E1
The volume cannot be migrated. Check the
configuration definition file.
The target volume is an external volume mapped
for online data migration.
20E2
Release the Compatible FlashCopy pair, and then
migrate the volume.
The migration source volume is the primary or
secondary volume of Compatible FlashCopy.
22FA
Release the Compatible FlashCopy pair, and then
migrate the volume.
The migration target volume is the primary or
secondary volume of Compatible FlashCopy.
22FB
Install Auto LUN, and then migrate the volume.
Auto LUN is not installed on the storage system.
2301
Check the configuration information of your
storage system.
The shared memory which is necessary to use Auto
LUN is not installed or the initial setting is not
completed.
2302
None. This migration plan cannot be executed.
The LBA size does not match between the
migration target volume and the migration source
volume.
2306
Reduce the number of pairs set in the storage
system, and then migrate the volume.
The maximum number of pairs which can be set
in the storage system is exceeded.
2309
48
Using RAID Manager for manual Auto LUN