Hot-plug sas and sata hard drive options, Removing hard drive blanks, Removing hard drive bezel blanks – HP ProLiant DL360 G7 Server User Manual
Page 46
Hardware options installation 46
Hot-plug SAS and SATA hard drive options
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number ("
" on page
•
Hard drives must be SFF types.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Removing hard drive blanks
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Remove the component as indicated.
Removing hard drive bezel blanks
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1.
Remove hard drives 1 and 2 ("
Removing a hot-plug SAS hard drive
" on page