HP ProLiant BL465c G5 Server-Blade - Manual (Page 25)

Hardware options installation 25
11. Remove the thermal interface protective cover from the heatsink.
12. Align the slot in the heatsink with the tab on the processor retention bracket.
CAUTION: Heatsink retaining screws should be tightened in diagonally opposite pairs (in an
"X" pattern).
NOTE: The T-15 Torx screwdriver is attached to the server access panel.
13. Install the heatsink.
14. Install the access panel (on page 14 ).
15. Install the server blade (" Installing a server blade " on page 16 ).