HP Insight Control Software for Linux - Manual (Page 198)

When a new set of credentials is entered with the Configure
→Management Processor→Credentials...
task, Insight Control for Linux attempts to find a user with the same user name. If one is found, the
user password is changed to match the new credential. If no match is found, then the new credentials
are placed in slot 15, overwriting the credentials.
For this reason, do not store credentials, other than those for Insight Control for Linux, in slots 15
and 16.
24.2 Deploying WBEM provider components using Configure or Repair
Agents task
IMPORTANT:
•
SLES 10 SP3 provides a version of libvirt and sblim-indication_helper on the
distribution media. For the Configure
→Configure or Repair Agents task to work properly, both
must be installed on the SLES 10 SP3 Linux Xen host. If these are not installed, the Configure
or Repair Agents installation fails with an error message. SLES 10 SP3 also provides
OpenWBEM CIMOM, which must be removed or not installed on the SLES 10 SP3 Linux Xen
host. The Configure or Repair Agents deploys Open Pegasus, libcmpiutils, Libvirt-CIM,
and sblim-cmpi-base to the SLES 10 SP3 Linux Xen hosts.
To deploy the WBEM provider components, you must deploy the following components:
On RHEL 5.3 and RHEL 5.4:
•
xen
•
xen-libs
•
kernel-xen
•
kernel-xen-devel
•
sblim-cmpi-base
•
tog-pegasus
On RHEL 5.3 and RHEL 5.4, Configure
→Configure or Repair Agents does not deploy WBEM
providers. In addition, you must perform these steps:
1.
Install the following virtualization packages on the virtual machine host before registering with
VMM:
•
libcmpiutil
•
libvirt-cim
•
sblim-cmpi-base
•
tog-pegasus
2. Configure tog-pegasus.
3. To enable the root user to connect to tog-pegasus remotely, make sure the following line
is in /etc/Pegasus/acces.conf:
*:root:wbemNetwork
4. Restart tog-pegasus on the virtual machine host.
On SLES 10 SP3 and SLES 11:
•
xen
•
xen-devel
•
xen-libs
•
xen-tools
•
kernel-xen
198 Advanced topics