HP ProLiant SL390s G7 Server - Manual (Page 25)

Hardware options installation 25
7. Rotate the drive carrier handle down.
8. Lock the drive carrier latches.
9. Install the server into the chassis (" Installing the server into the chassis " on page 21 ).
10. Connect the peripheral devices to the server.
11. Power up the server (" Powering up and configuring the server " on page 23 ).
NOTE: LFF hard drives are illustrated in the figures in this guide. SFF hard drives are also
supported.
Removing a drive
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
1. Back up all server data on the drive.
2. Power down the server (on page 15 ).
3. Disconnect all peripheral cables from the server.
4. Remove the server from the chassis (on page 15 ).
5. Slide the drive carrier latches to unlock the drive handle.
6. Raise the drive handle.