Sending a test e-mail – HP XP P9500 Storage User Manual
Page 58
3.
Select Enable in Mail Notice.
4.
Select IPv4, IPv6, or Host Name, and enter the IP address or host name of the mail server.
5.
In SMTP-AUTH, select Enable to use SMTP authentication. Enter the account and password for
SMTP authentication
Select Disable not to use SMTP authentication.
6.
Enter addresses in the From Address (required) and Return Address (optional).
7.
In To Address, add an e-mail address:
a.
Select a blank row in the list.
b.
Enter an e-mail address in the text box.
c.
Select To, Cc, or Bcc for the attribute.
d.
Click Update.
8.
Repeat the previous step for all e-mail addresses.
To delete an e-mail address, select the target address in the list, and click Delete. You can
select multiple addresses and delete all of them at once.
To change an e-mail address, select the target address in the list and perform the same
operation for adding an address.
9.
Click Apply to apply the settings to the storage system.
Sending a test e-mail
After configuring e-mail notification, you can send a test e-mail to confirm your settings.
Prerequisites
•
You must have a Security Administrator account with an Initial Configuration role to perform
this task.
•
The mail server must be completely configured before you begin.
To send a test e-mail:
1.
Click Settings
→Environmental Setting→E-mail Information. The E-mail Information window
opens.
2.
Click
to change to Modify mode.
3.
Make sure that Mail Notice is set to Enable and that the settings in the window are correct.
4.
Click Test Send. A confirmation message appears.
5.
Click OK.
6.
Confirm that mail clients received the e-mail with the reference code 7FFFFF.
An example of a test e-mail follows:
HP
Date: FRI 03 OCT 2009 10:10:10 +9000 (JST)
To: [email protected]
From: [email protected]
Reply-To: [email protected]
Subject: P9500 Report
Date : 03/10/2009
Time : 10:09:30
Machine : HP-P9500(Serial# 64019)
RefCode : 7FFFFF
Detail: This is Test Report.
The field definitions in the test e-mail are listed in the following table:
58
Configuring the Remote Web Console environment