HP ProLiant DL585 G2 Server - Manual (Page 41)

Hardware options installation 41
• DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the banks
furthest from each processor.
NOTE: If all four banks on a memory node (" DIMM slot identification " on page 9 ) are
populated, the maximum memory clock speed is 533 MHz. If two or fewer banks on a
memory node are populated, the maximum memory clock speed is 667 MHz.
To install a DIMM:
1. Power down the server (on page 27 ).
2. Remove the processor memory module, and open the cover (" Removing the processor memory
module " on page 32 ).
3. Open the DIMM slot latches.
4. Install the DIMM.
Hard drive guidelines