HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 16)

Commands 16
Item Description
-we Optional. Specifies the amount of time, in minutes, to wait between activating or rebooting
VC-Enet modules. This command is required for some MPIO/teaming software on the server
blades in the enclosure. The default is 0, or no delay.
-wf Optional. Specifies the amount of time, in minutes, to wait between activating or rebooting
VC-FC modules. This command is required for some MPIO/teaming software on the server
blades in the enclosure. The default is 0, or no delay.
-cp Optional. Password for the configuration backup file. Supported in VCM firmware versions
3.00 and higher. The default is no password.
*In a multi-enclosure environment, this must be the IP address of the active OA in the primary enclosure.
Examples
Update multiple modules in an enclosure imported into a VC domain:
vcsu -a update -i 192.168.1.100 -u Administrator -p password -vcu John -
vcp vcPass -l C:\images\vcfw-120.bin
Update a single module in an enclosure not imported into a VC domain:
vcsu -a update -i 192.168.1.100 -u Administrator -p password -l
vcfw121.bin -b 3
Update a single module in an enclosure managed by the VC domain:
vcsu -a update -i 192.168.1.100 -u Administrator -p password -vcu John -
vcp vcPass -l C:\images\vcfw-120.bin -b 3
Perform an update and specify an activation ordering method:
vcsu -a update -i 192.168.1.100 -u Administrator -p password -vcu John -
vcp vcPass -l C:\images\vcfw-120.bin -oe serial -of parallel
Perform an update using a firmware image from a web server address:
vcsu –a update –i 192.168.1.100 –u Administrator –p password –l
http://www.myserver.com/vcfw-120.bin
Perform an update using a firmware image from an FTP server on the network:
vcsu –a update –i 192.168.1.100 –u Administrator –p password –l
ftp://user:[email protected]/vcfw-120.bin
Perform an update of the same firmware version on a degraded module:
vcsu -a update -i 192.168.1.100 -u Administrator -p password -l
C:\images\vcfc-120.bin -f version,health
version
Display the current running firmware version on all modules in a specific target enclosure.
Item Description
Syntax vcsu -a version -i <IP> -u <USER> -p <PWD> [-b <BAY>]
Parameters:
IP IP address of the active OA in the enclosure*
USER Name of the OA user with privileges to access all enclosure interconnect bays. Minimum
length is 3 characters.
PWD Password of the OA user. Minimum length is 3 characters.
BAY Optional. The bay number of the target module. If not specified, the default is all supported