Accessing the hp apm through the serial port, Saving configurations, Topology and inventory – HP ProLiant SL2500 Scalable System User Manual
Page 25: Showing the rack
Command Line Interface 25
2.
When prompted, enter the assigned IP address or FQDN name of HP APM.
3.
Enter Administrator.
4.
Enter a valid password. The CLI command prompt appears.
5.
Enter commands for HP APM.
6.
To terminate the remote access Telnet session, close the communication software or enter EXIT,
LOGOUT, or QUIT at the CLI command prompt.
Accessing the HP APM through the serial port
You can also access the HP APM through the serial port. For more information, see "Serial Port Configuration
(on page
)."
Saving configurations
You must save your configurations. Otherwise, the configuration will be lost when you reset or reboot the HP
APM.
To save a configuration, enter SAVE.
Topology and inventory
HP APM collects information from connected enclosures, including:
•
SL enclosure product names
•
SL enclosure product identifiers (SKU)
•
SL enclosure serial numbers
•
Node MAC addresses
To show this information using the previous configuration image as an example, use any of the following
commands.
Showing the rack
To show the contents of the rack, enter SHOW RACK. The rack information appears, including the product
name, product SKU, and product serial number of the chassis.
For example, the following text might appear:
APM-D4C9EFCB01CA> show rack
1: Display ports
1: SL enclosure
Product Name :HP ProLiant s6700
Product SKU :
Serial Number:
UID :off
Status :
1 : Compute node (active)
2 : Compute node (active)
3 : Compute node (active)
4 : Compute node (active)
5 : Compute node (active)