Setting the time, Setting the session timeout, Setting the uid led – HP ProLiant SL2500 Scalable System User Manual
Page 60: Showing information
General commands 60
the power manager name, press Enter. Naming the HP APM is optional. This is the name that appears in
log entries on the syslog server as well as the CLI prompt.
Setting the time
To set the time, enter SET TIME <month> <day> <year> <hour> <minute>
where:
•
<month> is the month.
•
<day> is the day.
•
<year> is the year.
•
<hour> is the hour, in 24-hour format. For example, enter 3:00 p.m. as 15.
•
<minute> is the minute.
HP APM does not automatically adjust for Daylight Savings Time.
The time remains on this setting until you issue the RESET FACTORY command.
Setting the session timeout
To set the SSH and Telnet inactivity timeout, enter SET TIMEOUT {<timeout_value> | NONE}
where <timeout_value> is the timeout value measured in seconds.
For example, to set a 30-second timeout, enter:
SET TIMEOUT 30
If you specify NONE, then no timeouts are set. For example, enter:
SET TIMEOUT NONE
The timeout values are in increments of 5 seconds. The minimum timeout value is 15 seconds and the
maximum timeout value is 21,600 seconds (6 hours).
Setting the UID LED
To activate the UID LED, enter SET UID ON.
To deactivate the UID LED, enter SET UID OFF.
If there is a parameter specified such as <PORT#> <DMPORT#>, the UID of the chassis is turned on/off.
Showing information
To show information, enter SHOW INFO. The following information appears:
•
Manufacturer
•
Product Name
•
Part Number
•
Spare Part Number