HP ProLiant SL2500 Scalable System - Manual (Page 77)

CLI commands 77
NOTE: Only an Administrator can add or enable a new user account.
• Command:
ADD ACCOUNT "<username>"
• Description:
o Adds a new user to the system.
o A single HP APM is capable of supporting up to 10 added accounts. The built-in Administrator
account is the default and cannot be deleted.
o All user accounts have the same permissions.
o Each user account has its own login credentials.
— After a command is entered with a valid username, you are prompted to enter a password for
the new account. After the completion of the password entry, the new account is available for
logging into the system.
— If the password field is not specified, then the password appears after this command is entered
and the username does not already exist.
o Login accounts and passwords are stored separately from the board configuration. A SHOW
CONFIG command does not reveal any ADD ACCOUNT commands.
Disable password
• Command:
DISABLE PASSWORD
• Description:
Disables the password protection feature. Disabling password protection also disables SSH and Telnet
network access.
Enable password
• Command:
ENABLE PASSWORD
• Description:
Enables the password protection feature. SSH and Telnet access requires the password feature to be
enabled.
Set password account
• Command:
SET PASSWORD
SET PASSWORD "<password>"
SET PASSWORD ACCOUNT "<user>"
SET PASSWORD ACCOUNT "<user>" "<password>"