HP ProLiant SL2500 Scalable System - Manual (Page 81)

CLI commands 81
Set IP
• Command:
SET IP {DHCP | <IP_ADDRESS> <IP_MASK>}
• Description:
Assigns static IP address and subnet mask or can be used to configure DHCP. If setting IP address and
subnet mask, both must be specified.
Accepts the NONE token to disable IPv4 access to HP APM.
Set gateway
• Command:
SET GATEWAY {NONE | <IP_ADDRESS>}
• Description:
Assigns or removes gateway IP address.
Set name
• Command:
SET NAME "<name>"
• Description:
Assigns a name to HP APM that will appear in the log and syslog entries. Name can be up to 80
characters in length.
Set power
• Command:
SET POWER {ON|OFF|ENABLE|DISABLE} {ALL | <PORT#> <DMPORT#> {<NODE#>|ALL}}
where:
ALL is used when the command applies to all nodes. You can also use it when the command applies to
all the server nodes in a particular SL server enclosure.
<PORT#> refers to the HP APM, PDM1, or PDM2 port numbers.
<DMPORT#> refers to the HP APM Distribution Module port number or HP Intelligent Modular PDU
Extension Bar outlet number.
<NODE#> refers to the SL server node.
• Description:
o Turns power on and off to SL enclosures.
o SET POWER ALL shows the HP Power Management Controller Utility hardware and firmware
versions as well as the license status of all servers in the enclosures.