HP ProLiant SL2500 Scalable System - Manual (Page 88)

CLI commands 88
UPGRADE IMAGE TFTP <ip_address> "<filename>"
o If using FTP protocol for upgrading HP APM, enter:
UPGRADE IMAGE FTP <ip_address> "<username>" "<password>" "<filename>"
• Description:
o Updates HP APM firmware using the specified protocol. Protocol can be either FTP or TFTP.
<ip_address> refers to the IP address of a server that contains the file to be transferred, and
filename is the file to be transferred. Following the transfer, HP APM will be upgraded and reset to
run the new image.
o The filename must be enclosed in quotes to preserve case.
Add zone
• Command:
ADD ZONE <zone_name> [[<PORT#> <DMPORT#>]] | [<PORT#> ALL] | [ALL]
• Description:
Adds one or more chassis to a zone named by <zone_name>. If the zone does not already exist, then
it will be automatically created and the specified chassis will be added.
You can create up to four zones.
The parameters enable the addition of all chassis on all HP APM ports, all the chassis plugged into an
HP APM port through a HP APM Distribution Module) or a specific chassis on a specified HP APM port
and HP APM Distribution Module port. The syntax is similar to other HP APM commands such as SHOW
POWER or SHOW RACK in how HP APM and HP APM Distribution Module ports are specified.
When adding a chassis to a zone, the chassis does not have to be present and plugged into the HP
APM. The HP APM issues a message in such cases, and therefore, the chassis does not exist. Zone
definitions do not require the hardware to be present . For HP APM operations that might use zones (for
example, SET POWER BASELINE), only those chassis that exist and are defined in the zone are
considered for the operation.
Examples:
ADD ZONE my_zone 1 5
Adds the chassis plugged into HP APM Distribution Module port 5 on HP APM port 1 to zone
MY_ZONE. If MY_ZONE did not already exist, it will be created.
ADD ZONE my_zone 1 all
Adds all the chassis plugged into an HP APM Distribution Module on HP APM port 1.
ADD ZONE my_zone all
Adds all chassis on the HP APM to zone MY_ZONE.
ADD ZONE BLUE 1 ALL 2 ALL 3 1
You can also use ALL by itself instead of a PORT DMPORT pair.
For example:
ADD ZONE BLUE ALL
Zones cannot overlap.