HP ProLiant SL2500 Scalable System - Manual (Page 91)

CLI commands 91
Set SNMP contact
• Command:
SET SNMP CONTACT "<sysContact>"
• Description:
Sets the MIB II sysContact field.
Set SNMP location
• Command:
SET SNMP LOCATION "<sysLocation>"
• Description:
Sets the MIB II sysLocation field.
Set SNMP trapdest
• Command:
SET SNMP TRAPDEST <<ip_addresses>|NONE>
• Description:
o Sets the IP addresses where SNMP traps are sent.
You can set up to four SNMP trap destinations. For example, enter:
SET SNMP TRAPDEST x.x.x.x y.y.y.y z.z.z.z a.a.a.a
If you specify NONE, then no trap destinations are set. For example, enter:
SET SNMP TRAPDEST NONE
o HP APM supports the following SNMP traps:
NOTE: SNMP traps denoted by an * are not supported on the HP ProLiant s6500 Chassis.
— cpqRackNameChanged
— cpqRackEnclosureRemoved
— cpqRackEnclosureInserted
— cpqRackEnclosureFanRemoved *
— cpqRackEnclosureFanInserted *
— cpqRackEnclosureFanFailed
— cpqRackEnclosureFanOK
— cpqRackPowerSupplyFailed
— cpqRackPowerSupplyOK
— cpqRackPowerSupplyRemoved
— cpqRackPowerSupplyInserted
— cpqRackServerBladeRemoved