HP ProLiant SL2500 Scalable System - Manual (Page 93)

CLI commands 93
Add RADIUS server
• Command:
ADD RADIUS SERVER <ip_address> <shared_secret>
• Description:
Specifies an initial, or additional RADIUS server to HP APM’s list of authentication servers. The
authentication proceeds in the same order that these servers were added to the configuration.
Enable RADIUS
• Command:
ENABLE RADIUS
• Description:
Enables HP APM as a RADIUS client.
Disable RADIUS
• Command:
DISABLE RADIUS
• Description:
Turns off RADIUS authentication on HP APM. Authentication through RADIUS no longer takes place, but
password checking is still done against the local password if that is still enabled. Does not clear out the
configured RADIUS servers.
Remove RADIUS server
• Command:
REMOVE RADIUS SERVER <index>
• Description:
Removes a previously added RADIUS server that matches the index indicated with the SHOW RADIUS
command.
Show RADIUS
• Command:
SHOW RADIUS
• Description:
Shows the currently configured RADIUS servers.
Set RADIUS pollnum
• Command: