HP IO Accelerator for BladeSystem c-Class - Manual (Page 28)

Utilities 28
• Manufacturer number
• Part number
• Date of manufacture
• Power loss protection status
• PCIe bus voltage (average, minimum, maximum)
• PCIe bus current (average, maximum)
• PCIe bus power (average, maximum)
• PCIe power limit threshold (watts)
• PCIe slot available power (watts)
• PCIe negotiated link information (lanes and throughput)
Block device information:
• Manufacturer's code
• Manufacturing date
• Vendor and sub-vendor information
• Format status and sector information (if device is attached)
• FPGA ID and Low-level format GUID
• PCIe slot available power
• PCIe negotiated link information
• Card temperature, in degrees Centigrade
• Internal voltage, average and maximum.
• Auxiliary voltage: average and maximum.
• Percentage of good blocks, data and metadata
• Lifetime data volume statistics
• RAM usage
Error mode information: If the IO Accelerator is in minimal mode, read-only mode, or write-reduced mode
when fio-status is run, the following differences occur in the output:
• Attach status is Status unknown: Driver is in MINIMAL MODE:
• The reason for the minimal mode state appears (for example, Firmware is out of date. Update
firmware.)
• "Geometry and capacity information not available." is displayed.
• No media health information appears.
fio-sure-erase