HP Linux Server Management Software - Manual (Page 24)

Toolkit utilities 24
REBOOT return codes
There are no return codes for the REBOOT utility.
REBOOT command-line examples
Command-line argument Description
REBOOT A: This command reboots the system to the A: drive.
REBOOT PXE This command reboots the system by itself to the PXE NIC.
Using SETBOOTORDER
SETBOOTORDER enables you to set the order in which devices are booted, including diskette drives,
CD-ROM drives, hard drives, PXE, and USB devices. This utility sets the boot order only for devices that exist
for a server. The devices can be set to boot in any order.
SETBOOTORDER cannot be used to set the storage controller order. You must use the CONREP utility. For
more information about setting the controller order, see "Using CONREP (on page
31 )."
NOTE: Any changes made to the SETBOOTORDER take affect at the next reboot. For HP ProLiant
servers with Oxx ROM Family (most 100 series servers), only one device can be set as the boot
device and others cannot be re-ordered. These Oxx servers do not support the default or usb
parameters.
SETBOOTORDER command-line syntax
setbootorder [floppy cdrom pxe hd usb | default] [/?]
SETBOOTORDER command-line arguments
Options are disabled if not listed in the argument.
Command-line argument Description
floppy cdrom pxe hd usb The order of these arguments sets the boot order for the system
devices. Each term can be used only once in any order. It is not
necessary to use all terms. HP ProLiant 100 series servers can only
pass in one option.
default This argument resets the boot order to the factory default.
/? This argument displays help information.
SETBOOTORDER return codes
Value Meaning
0 The boot order was set successfully.