HP Linux Server Management Software - Manual (Page 33)

Toolkit utilities 33
Processor Manufacturer : Intel
XML System Configuration : conrep_SL160zg6_20090728.xml
Hardware Configuration : sl160zconrep.dat
Saving configuration data to sl160zconrep.dat.
CONREP Return code: 0
NOTE: The file names after the -x and -f options must be specified, otherwise, the default file
names Conrep.xml and Conrep.dat are used, respectively.
NOTE: A platform specific XML file needs to be used for HP ProLiant 100-series servers. If you
use the default name this may cause an error while running the CONREP utility.
CONREP –l (Load from Data File) Example Usage for HP ProLiant
100 series servers
To load the BIOS configuration settings from a previously captured/edited data file (in this case
“sl160zconrep.dat”) to an SL160z G6 server:
[root@ilo002481b08134 conrep]# ./conrep -l -xconrepSL160zg6_20090728.xml -fsl160zconrep.dat
conrep 3.00 - SmartStart Scripting Toolkit Configuration Replication Program
Copyright (c) 2007-2009 Hewlett-Packard Development Company, L.P.
System Type: ProLiant SL160z G6
ROM Date : 07/28/2009
ROM Family : O33
Processor Manufacturer : Intel
XML System Configuration : conrep_SL160zg6_20090728.xml
Hardware Configuration : sl160zconrep.dat
Loading configuration from sl160zconrep.dat.
ASM values not set! aborting
CONREP Return code: 0
NOTE: The "ASM values not set! aborting" message shown in the output above is a spurious
error message meant only for 300-series and above ProLiant systems. It should be ignored if seen
on an HP ProLiant 100-series server.
CONREP Data File Sample Contents for HP ProLiant 100 series
servers
A typical data file generated by CONREP is similar to the following:
<Conrep_data>
<Section name="Controller_Order">
<Id0>0e 11 40 80 </Id0>