HP NonStop G-Series - Manual (Page 133)

Command Interpreter
HP AutoSYNC User’s Guide—522580-016
8-41
ALTER SYNCFILESET
The name of the input file is in the format of ZBKnnnnn for BACKUP and
ZRSnnnnn for RESTORE, where nnnnn is a serial number. The files are
placed in the MapDB subvolume. The exact file name is displayed in the
syncuser’s log file SLnnnggg.
Input files are not created if no files require synchronization. For BACKUP, the
input file is always created when files are synchronized. For RESTORE, the
input file is created only when files are synchronized and the MAPNAMES
option is specified.
For OSS file sets, the BACKUP input files is an entry-sequenced file that
contains the names of the files and directories to be synchronized, in addition
to internal file information.
KEEPS[ECURITY] | NO KEEPS[ECURITY]
the Guardian security settings "rwep" of the source file are retained on the
destination file.
KEEPSECURITY overrides the SECURE and NETWORKSECURE options.
LIST[ALL] | NO LIST[ALL]
includes all file names that are processed by BACKUP and RESTORE in the
log.
OPENU[PDATE] interval [SECONDS | MINUTES | HOURS]
| NO OPENU[PDATE]
specifies that a source file that is opened for update is eligible for
synchronization. By default, AutoSYNC does not synchronize files that are
opened for update. OPENUPDATE overrides the default behavior.
interval is the number of seconds, minutes, or hours during which the source
file must remain unchanged to be considered for synchronization. The default
unit of time is MINUTES. If interval is omitted, the OPENUPDATE interval is
the same as the synchronization interval.
The time elapsed is computed from the last time the file was modified. The
candidate files can be opened for WRITE or READ-WRITE access. The
exclusion mode must be SHARED or PROTECTED. The Autosync global
SYNCRECOVER parameter must be set to ON.
OPENUPDATE is ignored if:
•
a file is opened for EXCLUSIVE access or,
•
a file is audited or,