HP VMA-series Memory Arrays - Manual (Page 185)

AM456-9026A HP VMA SAN Gateway User’s Guide 185
Name Resolution Commands
hostname <hostname>
no hostname
Set or clear the system hostname.
[no] ip name-server <IP address>
[no] ip domain-list <domain>
[no] ip host <hostname> <IP address>
The commands configure DNS servers, specifies which domain(s) to try unqualified hostnames in,
and defines hostname/IP mappings for /ETC/HOSTS .
show hosts
Show all values configured by the group of commands above: hostname, name servers, domain
name list, and static host mappings.
Routing Commands
WARNING! Do not try to add the default gateway using the ip route command. For more information, on
the function and use of a default gateway, see your network administrator.
ip route <network prefix> <network mask> <next hop IP address>
no ip route <network prefix> <network mask> [<next hop IP address>]
Set or remove a static route. If it is called with only a network prefix and mask, it deletes all routes
for that prefix.
show ip route
Display the routing table in the system, which includes dynamic routes as well as any active static
routes.
show ip route static
Display the list of configured static routes.
Media Management Commands
This section describes commands for managing and monitoring block storage (vSHARE) media
devices.