HP Command View for Tape Libraries Software - Manual (Page 152)

4. Click Finish to complete the wizard or Cancel to cancel your changes.
Removing an Access Control Group
To remove an Access Control Group:
1.
In the Library window, click the Configuration tab. In the left panel, select Host Access from
the left panel.
2. Remove already created ACGs by doing one of the following:
•
In the right panel, select the ACG you want to remove, and select Actions
→Remove Access
Control Group.
•
In the right panel, select Actions-
→Remove all ACG to remove all created ACGs.
3. Click YES on the confirmation dialog and return to the Library window.
Synchronizing host access settings
If you have made interface controller host access changes directly through the interface controller
Telnet or serial interface instead of using the Interface Manager card or Command View TL, the
interface controller will be out of sync with the Interface Manager card. You must then synchronize
the settings which reapplies the Interface Manager card settings to the interface controllers.
1.
In the Library window, click the Configuration tab.
2. In the right panel, select Actions
→Synchronize Secure Manager Settings.
Viewing the device map
The device map shows how a particular host HBA sees the configuration within a library. The host
HBA Properties dialog shows the device map.
1.
In the Library window, click the Configuration tab.
Previously created Access Control Groups (ACG) with the list of the host HBAs that currently
have access to the library appear in the right panel.
152 Advanced features in the GUI