HP Command View for Tape Libraries Software - Manual (Page 36)

3. Do one of the following:
•
To edit the library name, select Actions
→Edit Library Name.
•
To edit the system date and time, select Actions
→Edit Library Date/Time.
Select either Set Clock Manually or Synchronize Clock with NTP Server.
When synchronizing with NTP servers, enter the IP addresses of up to three NTP servers.
Click Check to verify connectivity.
•
To edit the contact information, select Actions
→Edit Contact Information.
4. Make the required changes, and then click OK. The library settings are stored in the memory
of the Interface Manager card.
Changing the network settings of the Interface Manager card
Following are the network settings that pertain to the Interface Manager card of an EML or ESL
E-Series library.
•
IPv4 network settings
Hostname (editable) ◦
◦ Address configuration (editable)
◦ IP address (editable)
◦ Subnet mask (editable)
◦ Gateway (editable)
◦ DNS domain name (editable)
◦ DNS addresses (editable)
•
IPv6 network settings
Hostname (editable) ◦
◦ Domain name (editable)
◦ DNS servers (primary, secondary, and tertiary)
◦ Stateless addressing
◦ DHCP addressing
◦ Static addressing
•
MAC Settings
MAC address (not editable) ◦
◦ Link selections (not editable)
Only the network settings can be edited. To edit the network settings:
1.
If necessary, obtain the required network settings from your network administrator.
2. In the Library window, click the Configuration tab.
3. Under Network Settings, choose the IP version for which you'll configure your network settings.
IPv4 addresses are the shorter, traditional addresses.
IPv6 addresses are the second generation, 128–bit addresses.
4. Select Actions
→Edit Network Settings to display the Network Settings dialog box.
36 Command View TL GUI