HP Insight Vulnerability and Patch Manager Software - Manual (Page 34)

Installation and configuration 34
Post-installation configuration
1. Log in to HP SIM from an account with administrator privileges.
NOTE: An administrator can add new users and set up existing users to access Vulnerability and
Patch Management Pack. For instructions, see the HP Systems Insight Manager Installation and
Configuration Guide.
IMPORTANT: This configuration step must be completed for Vulnerability and Patch Management
Pack to function properly.
2. Select Options>Protocol Settings>Global Protocol Settings, and configure the WBEM credentials
to enable access to target systems using one of the following options.
○ Configure settings for the \user account if Vulnerability and Patch Management Pack is
located on the HP SIM server
○ Configure settings for the DOMAIN\user account if Vulnerability and Patch Management
Pack is on a separate server.
3. Enter the Windows administrator account credentials in the Default 1 field and Red Hat
administrator group credentials in the Default 2 field. For systems with individual settings,
configure WBEM credentials using the System Protocol Settings. For information, see the
“
Troubleshooting ” section.
4. Click OK.