HP Mini 5102 - Manual (Page 121)

Select To do this
● Set the UEFI boot order: Windows Boot Manager.
● Set the legacy boot order:
◦ 1st boot device: Notebook hard drive
◦ 2nd boot device: USB floppy
◦ 3rd boot device: USB CD-ROM
◦ 4th boot device: USB hard drive
◦ 5th boot device: Notebook Ethernet
◦ 6th boot device: SD card
Device configurations ● Enable Fn Key Switch
● Enable/disable USB legacy support. When enabled, USB
legacy support allows the following:
◦ Use of a USB keyboard in Computer Setup even
when your operating system is not running.
◦ Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
● Enable/disable fan always on while connected to an AC
outlet.
● Enable/disable Data Execution Prevention (select
models only). When enabled, the processor can disable
some virus code execution, which helps to improve
computer security.
● Enable/disable LAN power saving mode.
● Set the SATA (Serial Advanced Technology Attachment)
device mode. The following options are available:
◦ AHCI (Advanced Host Controller Interface)
◦ IDE (Integrated Drive Electronics)
● Enable/disable HP QuickLook.
● Enable/disable HP QuickLook preboot authentication on
HP QuickLook boot.
● Enable/disable HP QuickWeb.
● Enable/disable HP QuickWeb: Write Protect (disabled by
default).
● Enable/disable Intel® HT Technology.
● Enable/disable Wake on USB (disabled by default).
● Enable/disable Numlock state at boot: Off /On (disabled
by default).
Built-in device options ● Enable/disable the wireless switch state.
● Enable/disable embedded WLAN device radio.
Computer Setup menus 111