HP ProLiant xw460c Blade Workstation User Manual
HP Computers
Advertising
Table of contents
Document Outline
- HP GbE2c Ethernet Blade Switch for c-Class BladeSystem User Guide
- Notice
- Contents
- Introduction
- Overview
- Additional references
- Features
- Switch architecture
- Supported technologies
- Layer 2 switching
- IEEE 802.1 Q-based VLAN
- Spanning Tree Protocol
- SNMP
- Port mirroring
- Port trunking and load balancing
- TFTP support
- Store and forward switching scheme
- BOOTP
- NTP
- RADIUS
- TACACS+
- SSH and SCP
- XModem
- IGMP Snooping
- Jumbo frames
- Auto-MDI/MDIX
- Auto-negotiation of duplex mode and speed
- Redundant images in firmware
- External components
- Installing the switch
- Replacing and upgrading the switch
- Regulatory compliance notices
- Technical specifications
- Performing a serial download
- SNMP MIBs support
- Electrostatic discharge
- RJ-45 pin specification
- Troubleshooting
- Forgotten administrator user name and password that was configured on the switch
- Health LED on the switch is not on
- Health LED on the switch stays amber for more than 30 seconds and switch does not boot
- No link LED appears, even after plugging the Category 5 cable in the RJ-45 connector of the external port
- Cannot access the switch serial console interface using null modem connection from a PC Terminal Emulation Program
- Error message that the switch failed to complete the system self-testing appears on the serial console screen
- The switch fails to get its IP settings from the BOOTP server, even though by default it is configured for BOOTP
- The keyboard locks up when using HyperTerminal to log on to the switch through the console interface
- Cannot connect to the switch console interface remotely using Telnet
- Password is not accepted by the switch using the remote console interface immediately after a reboot
- Cannot connect to the switch console interface remotely using SSH
- Cannot connect to the switch SNMP interface
- The port activity LEDs continuously indicate activity after connecting more than one port to another switch or destination device
- Cannot connect to the switch remotely using the Web interface
- Cannot enable a port in multiple VLANs while configuring VLANs
- The switch does not let the user enable two adjacent ports into two different VLANs while assigning the ports to VLANs
- While using TFTP to download firmware, the switch fails to connect to the TFTP server, or after connection the download fails
- The switch fails to connect to the TFTP server while using TFTP to download or upload a configuration file, or after connection the download or upload fails
- The console screen displays a message to change the baud for the terminal emulation session for XModem transfer after forcing the switch into the download mode, and does not display CCCC...
- The download fails after starting to download the firmware file
- The switch configuration is corrupt
- Acronyms and abbreviations
- Index