HP Latex 3000 Printer - Manual (Page 12)

2. Position the Dual Roll Center Support under the center of the dual roll spindle.
3. Pull down the long lever.
When engaging the support, make sure that the position of the support bearings corresponds to the
grooves of the differential cover and that the two sets of bearings are approximately the same distance
from the middle of the spindle to maximize their contact.
4. Repeat the procedure for the ouput Dual Roll Spindle.
5. You can now feed the substrates into the printer.
6. Once the substrate is aligned, automatic substrate edge detection can be run. If this automatic process
fails, or if you are using a roll width not within the specifications (see
Specifications on page 9 ),
introduce the substrate edge values manually.
Physically measure the position of the substrate edges on the Dual Roll Spindle ruler.
The Dual Roll Spindle ruler , in inches and centimeters, uses positive (+) signs on one side and negative
(-) signs on the other side. Check the measured values in the
Appendix — Conversion Tables
on page 10 , to obtain the values you can insert manually in the Internal Print Server.
8 Chapter 3 Loading the Dual-Roll Spindle ENWW