HP NC522SFP Dual Port 10GbE Gigabit Server Adapter - Manual (Page 11)

Installing an adapter 11
2. Using a correctly sized Phillips head screwdriver, carefully remove the two board lock screws
located at the top and bottom of the connector.
3. Remove the standard profile bracket and place the low profile bracket over the connector. Be careful
not to damage the connector or bend the low profile bracket.
4. Reinstall the two Phillips screws.
5. Orient the SFP modules with the label side down and then reinstall the modules all the way into their
sockets until they click into place and latch securely.
Connecting the network cable
The HP NC522SFP Dual Port 10 GbE Server Adapter uses two SFP+ ports. These ports support either
direct attached cable or optical modules. See Cable specifications (on page 12 ) for the maximum cable
length.