HP Integrity NonStop H-Series - Manual (Page 145)

Command Interpreter
HP AutoSYNC User’s Guide—522580-021
8-51
ALTER SYNCFILESET
When processing large file sets, AutoSYNC divides the synchronized files into
subsets, each processed by a separate BACKUP process. BACKUP
performance decreases significantly with the number of files it processes. To
avoid performance degradation, AutoSYNC starts multiple BACKUP
processes, in sequence, and assigns to each no more than the configured
num-of-files.
The default is 1000.
NETWORKSECURE | NO NETWORKSECURE
enables or disables changing the security of the destination files for network
access.
By default this option is enabled and file security is changed as follows:
The default is NETWORKSECURE, but the SECURE option overrides
NETWORKSECURE.
NOSAFEGUARD | NO NOSAFEGUARD
specifies that the Safeguard ACL for a source Enscribe disk file is not
propagated to the destination when the file is synchronized. A warning is
written to the log file to notify the user that the Safeguard setting for the source
file has been turned off on the destination.
The default is NO NOSAFEGUARD and the ACL for a source file is
propagated to the synchronized destination file.
RECOVERY | NO RECOVERY
enables or disables the recovery option.
If recovery is enabled, AutoSYNC saves a copy of an existing destination file to
an archive subvolume before it restores a later copy of the file. If a failure
occurs during the synchronization and the file is corrupted, the archived copy is
recovered and replaces the corrupted file.
This option overrides the global parameter [AUTO]SYNCRECOVER.
By default, recovery is enabled.
RENAMEO[PEN] | NO RENAMEO[PEN]
Source file security Destination file security
“A” “N”
“G” “C”
“O” “U”
“-” “-”