HP M-series HA-Fabric Manager Software - Manual (Page 156)

156 Command Line Interface
Set command
Description Sets a variety of switch parameters.
Authority Admin session for all operands except Alarm, Beacon, and Pagebreak, which are available without
an Admin session.
Syntax
set
alarm [option]
beacon [state]
config [option]
log [option]
pagebreak [state]
port [option]
setup [option]
switch [state]
timezone
Operands
alarm [option]
Controls the display of alarms in the session output stream or clears the alarm log. [option] can
be one of the following:
clear
Clears the alarm log history. This value requires an Admin session.
on
Enables the display of alarms in the session output stream.
off
Disables the display of alarms in the session output stream.
beacon [state]
Enables or disables the flashing of the Logged-in LEDs according to [state]. This operand does
not require an Admin session. [state] can be one of the following:
on
Enables the flashing beacon.
off
Disables the flashing beacon.
config [option]
Sets switch, port, port threshold alarm, security, and zoning configuration parameters. See the
Set Config
command.
log [option]
Specifies the type of entries to be entered in the event log. See the Set Log command.
pagebreak [state]
Specifies how much information is displayed on the screen at a time according to the value given
by [state]. This operand does not require an Admin session. [state] can be one of the following:
on
Limits the display of information to 20 lines at a time. The page break functions affects the
following commands: Show (Alarm, Log), Zone (List, Members), Zoneset (List, Zones),
Zoning
(Active, List).
off
Allows continuous display of information without a break.
port [option]
Sets port state and speed for the specified port. The previous Set Config Port settings are
restored after a switch reset, port reset, or a reactivation of a switch configuration. See the Set
Port
command.