HP Smart Array P800 Controller - Manual (Page 26)

Upgrading or replacing controller options 26
c. Slide the batteries apart (2).
8. Dispose of the exhausted or faulty battery using environmentally approved procedures (" Battery
replacement notice " on page 51 ).
9. Position the new battery and the remaining good battery as indicated, push them together, and then
slide them until they are aligned. The batteries combine into one unit.
10. Install the battery clip.
a. Position the clip so that the hinges on the clip are next to the appropriate hinge pillars on the
batteries.
b. Hold the clip at about 30 degrees to the batteries.