HP LaserJet Pro CP1025nw Color Printer User Manual
Page 42
NOTE:
The installation CD is not required during a HP Smart Install. Do not insert the software
installation CD into the computer CD drive.
1.
Turn on the product, and then connect the USB cable to the product and the computer. The
installation program should start automatically.
●
If the HP Smart Install program does not start automatically, AutoPlay might be disabled on
the computer. Browse the computer and double-click the HP Smart Install drive to run the
program. If you cannot find the HP Smart Install drive, use the product installation CD to
install the software.
●
If the program prompts you to select a connection type, select the connection type you will
use to print to the product after installation.
2.
Follow the onscreen instructions to complete the product installation.
3.
When the installation is complete, if you want to verify that the product has a network IP address,
print a configuration page. Press and hold the product cancel
button until the ready
light blinks, and then release the button to print the configuration page.
Connect the product to a wireless network using WPS
If your wireless router supports Wi-Fi Protected Setup (WPS), this is the simplest way to set up the
product on a wireless network.
1.
Press the WPS button on your wireless router.
2.
Press and hold the Wireless button on the product control panel for two seconds. Release the
button when the wireless light starts blinking.
3.
Wait up to two minutes while the product establishes a network connection with the wireless
router.
NOTE:
If this method is not successful, try using the wireless network setup using the USB cable
method.
Connect the product to a wireless network using a USB cable
If your wireless router does not support WiFi-Protected Setup (WPS), use this method to set up the
product on a wireless network. Using a USB cable to transfer settings makes setting up a wireless
connection easier. After the setup is complete, you can disconnect the USB cable and use the wireless
connection.
1.
Insert the software CD into the computer CD tray.
2.
Follow the on-screen instructions. When prompted, select the Connect through a wireless
network option. Connect the USB cable to the product when prompted.
CAUTION:
Do not connect the USB cable until the installation program prompts you.
30
Chapter 4 Connect the product
ENWW