HP RDX Removable Disk Backup System - Manual (Page 19)

Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in
“ Attach mounting hardware ” on page 14. The server also incorporates a locking mechanism to hold
the RDX Removable Disk Backup System in place.
1. Push the server latch down to lock the drive into position.
2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
No mounting hardware used
1. Use the M3 screws provided with the server. Check that the holes in the chassis are aligned with
the holes in the sides of the drive and use a regular Phillips screwdriver to secure the M3 screws,
as shown in Figure 8 on page 19.
1. M3 screws, supplied
Figure 8 Securing drive, no mounting hardware used
2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
RDX Removable Disk Backup System 19