HP Smart Update Manager - Manual (Page 74)

Description Reboot options
If the following conditions are met, this argument causes
the server (or host server in a remote installation) to reboot: /r[eboot]
• The /reboot option is selected or given as a
command-line argument.
• All components selected for installation are successfully
installed.
•
At least one of the installed components requires a
reboot to complete its installation.
Displays the specified reboot message on remote consoles
connected to the server that you want to reboot. You must /reboot_message "reboot message"
use this argument with the /reboot option, or the
argument is ignored.
Delays the reboot of the server for the length of time that
the timeout_in_seconds variable specifies. You must /reboot_delay timeout_in_secs
use this argument with the /reboot option, or the
argument is ignored. Acceptable values are between 15
and 3600.
• The default timeout value is 15 seconds for Microsoft
Windows operating systems and 60 seconds for Linux.
•
For Linux, the reboot delay time is converted from
seconds to minutes, and any value under a full minute
(59 seconds or less) rounds to the next minute.
If the following conditions are met, this argument forces
the server to reboot: /reboot_always
• The /reboot_always option is selected or given as
a command-line argument.
•
All components selected for installation are successfully
installed.
Description Simulating HP SUM
This argument simulates the installation for a test run.
Nothing is installed. /dryrun
Description Nodes
Use this argument to log in to the remote nodes by using
the user ID. /user <username> or /username <username>
The user name needs to belong to the root or administrator
group.
Use this argument to use this password for the user ID
specified in the /user parameter (except for the OA
node). The password is used to log in to remote nodes. /password <password>
HP SUM also supports passwd and pwd
Use root (super user) username to start a session, and
inventory and update components when the credentials /su_username
specified in /username and /passwd do not have root
privileges to update components.
/su_username cannot be used with /use_sudo access
level.
NOTE: Specifying /targettype linux reduces
inventory time for deployments. This is an optional
command line argument.
74 Using legacy scripts to deploy updates