HP OmniBook XE2-DB Notebook PC User Manual
Page 31
Using the OmniBook
Expanding the OmniBook
Setup Guide
31
To replace a hard disk drive
You’ll need a small Phillips screwdriver to complete this procedure.
1.
From the Start menu, shut down the OmniBook.
2.
Unplug the AC adapter, if present, and remove the battery.
3.
Turn the unit bottom side up.
4.
Use a screwdriver to remove the hard disk drive locking screw.
5.
Slide and hold the hard disk drive latch.
6.
Slide the hard disk drive toward the edge of the OmniBook, then lift out.
7.
Insert the new hard disk drive and the locking screw.
8.
Insert the battery.
Note
If you are installing a new hard disk drive, you should create a Hibernate partition
on the drive before loading any software—see the instructions included with the
drive or go to the OmniBook website at www.hp.com/omnibook.