HP Networking Switch Power Supplies - Manual (Page 12)

12
Removing the power module
Follow these steps to remove the power module:
1. Use the Phillips screwdriver to unfasten the captive screw on the power module.
2. Hold the captive screw and pull out the handle of the power module.
3. As shown in Figure 9 , grasp the handle of the power module with one hand and
pull it out a little, support the bottom of the power module with the other hand, and
then pull the module slowly along the guide rails out of the slot.
Figure 9 Remove the power module
4. Put the power module on an antistatic mat.
5. Install the blank panel back to the power module slot, and fasten the captive screws.
CAUTION:
Before inserting a removed power module into a power module slot, make sure that
the LEDs on the power module are both off.