HP Deskjet 1125c Printer - Manual (Page 32)

17
When printing in DOS, there are two different ways you can adjust print settings: the HP DeskJet Control Panel for
DOS and DOS printer drivers.
HP DeskJet Control Panel for DOS
DOS users have access to many printer features through specific DOS printer drivers; however, many software
manufacturers do not develop printer drivers for their software programs. Use the DeskJet Control Panel to
specify the default printer setting for printing from your DOS program.
Note: HP DeskJet Control Panel does not support printing of special features.
Installing the HP DeskJet Control Panel for DOS
Before you install the Control Panel, make sure you have setup your printer and that the printer is turned on.
1 Insert the Starter CD into the CD-ROM drive.
2 At the DOS prompt C:\>, type the CD-ROM drive letter and change the directory to \driver\win\disk4,
e.g. D:\driver\win\disk4.
3 Type INSTALL and press ENTER.
4 Follow the instructions on your computer screen to complete installation.
Note: You can also install the HP DeskJet Control Panel from floppy disk 4.
Using the HP DeskJet Control Panel for DOS
To open the DeskJet Control Panel, at the DOS prompt, change your directory to C:\HP1120C, type DJCP and
press ENTER.
Use the Control Panel to select print settings that may not be available from some DOS programs. Duplicate
print settings that are selected from a DOS software program may override print settings selected in the Control
Panel. The Control Panel also allows you to clean and align the print cartridges for best print quality.
DOS Printer Drivers
Printer drivers are supplied by the manufacturers of DOS software programs. The recommended printer driver to
use is the HP DeskJet 1120. If that is not available use the HP DeskJet 870, 850 or 660.
Printing from DOS Software Programs
Section 2 - Printing Basics