HP NC370T PCI-X Multifunction Gigabit Server Adapter - Manual (Page 11)

Installing the adapter
2-2 HP NC370T PCI-X Multifunction Gigabit Server Adapter User Guide
Installing the adapter in a server
Refer to the HP ProLiant server documentation for additional information on how to safely
install a PCI card in the server.
CAUTION: If the server is not PCI Hot Plug compliant, power it down and unplug the power
cord from the power outlet before removing the server cover. Failure to do so may damage the
adapter or server.
1.
Remove the power cord and server cover. Then remove the expansion slot cover from a
PCI/PCI-X slot.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching them.
2.
Firmly seat the adapter in the PCI/PCI-X slot and secure the expansion slot cover.
Figure 2-1: Installing the adapter in a server
3.
Replace the server cover and plug in the power cord.
Connecting the network cable
Network connections for the NC370T PCI-X Multifunction Gigabit Server Adapter can
employ existing Category 5 UTP (or better) cable for Gigabit over copper transmissions. For
new installations, Category 5e (enhanced Category 5) or better cable is recommended.
To secure the cable, plug the cable connector into the RJ-45 port. Ensure that the tab on the
plug clicks into position, indicating that it is properly seated.
For more information, refer to “UTP cable specifications” in Appendix C.