HP XC System 2.x Software - Manual (Page 143)

date and time stamp: Submitted from host <lsfhost.localdomain>,
to Queue <normal>,CWD <$HOME>,
6 Processors Requested;
date and time stamp: Dispatched to 6 Hosts/Processors
<6*lsfhost.localdomain>;
date and time stamp: slurm_id=22;ncpus=6;slurm_alloc=n[13-15];
date and time stamp: Starting (Pid 11216);
date and time stamp: Done successfully.
The CPU time used is 0.0 seconds;
date and time stamp: Post job process done successfully;
Summary of time in seconds spent in various states by date and time
PEND PSUSP RUN USUSP SSUSP UNKWN TOTAL
11 0 7 0 0 0 18
A.8 Using a Resource Requirements String in an LSF Command
The following examples show how to use a resource requirement string in an LSF command.
• Run myjob on an Alpha/AXP host or an HP XC host if one is available, but not both:
$ bsub -n 8 -R "ALPHA5 || SLINUX64" \
-ext "SLURM[nodes=4-4]" myjob
If myjob runs on an HP XC host, the SLURM[nodes=4-4] allocation option is applied.
If it runs on an Alpha/AXP host, the SLURM option is ignored.
• Run myjob on any host type, and apply allocation options appropriately:
$ bsub-n 8 -R "type==any" \
-ext "SLURM[nodes=4-4];RMS[ptile=2]" myjob
If myjob runs on an HP XC host, the SLURM[nodes=4-4] option is applied. If myjob
runs on an HP AlphaServer SC host, the RMS ptile option is applied. If it runs on any
other host type, the SLURM and RMS options are ignored.
Examples A-9